Tie Rods The tie rods often consist of two rods, each with a nut and tie rod loosening. The length of a single rod up to 20n pad, but also set the tensioner

The Method of Determining the Limit State of the Tie Rod AccuratelyDue to a variety of factors, such as soil retaining material and soil arching effect within the soil, rod force is difficult to accurately determine. For security. In the traditional design method, the safety factor is quite large, w

The materials of the tie rods are 52350 and 5550 weldable structural steels in the European Standard "Hot-rolled Structural Steel Products Part...

In order to facilitate the design, it can be considered that the sheet piling between the adjacent tie rods are simply supported (the ratios thus bending moment...

The purpins are usually laid on two back-to-back channels with a gap in the middle allow the rod to pass through. The sheet piling width of the gap must take...

When the better soil layer covered with soft soil layer can be considered when setting up cantilever anchorage. This type of anchorage can be used to set the bar...

Steel sheet pile supporting balanced anchorageWhen designing the balanced anchor, it is assumed that the resistance increases as the depth increases, which is a triangular distribution. The top of the anchor plate is assumed to be located at 1/3 of the total depth of the subterranean anchor. The ste

Anchor plate position For an effective anchorage system, the anchor plate must lie outside the potential slip surface behind the steel sheet piles wall,

The total deformation of the wall consists of external deformation of the wall caused by the deformation, which does not require the end...

When the depth of sheet piling support or external load (such as heavy docks crane) is too large, the earth pressure can be reduced by the load-relief platform.