Publish Time: 2021-02-01 Origin: Site
For quay-wall construction of ports, in tunnels or river crossings combi-walls are used as retaining walls. The system consists of tubular piles equipped with connectors (named also interlocks, locking bars or clutches) compatible with U or Z type infill sheet piles. combi-walls that transfer the pressure of the main loads to the King piles are connected with E21 / C6 or E22 / C9 interlocks welded on both sides.
Here is the content list:
What is the basic structure of the combi-walls?
How to install combi-walls?
What are the notes for combi-walls installation?
Retaining wall structures based on steel piles are often the best solution to replace traditional, labor-intensive cast-in-place based combi-walls structures.Large diameter piles can be built into a continuous combi-walls by welding interlocking sections or complete sheet piles into them.
In a combi-wall, piles act as the load-bearing structure, while sheet piles installed in between make the wall continuous. Thanks to high-grade steel, our combi-walls have excellent bending stiffness and resistance.
Before installing combi-walls, the construction personnel shall first determine the important parts such as wall, ground, roof, beam and column according to the design drawings, and then clean the surface, in which the center line of the combi-walls shall be consistent with the center line of the block wall.
Combi-walls shall be arranged in staggered joints.
When the construction personnel install the combi-walls, they respectively pop out the double lines of the plate thickness up and down, and then prepare the combi walls with the same specifications.
Workers can cut out the specifications of combi-walls according to the wall specifications
After the workers cut, the two boards in the tenon on a piece of cement, and then the polymer mortar on the tenon.
The workers shall move the combi-walls board to the installation position and use iron sled to correct the combi-walls board, so that the polymer mortar can be extruded from the joint and then temporarily fixed with wooden wedge.
In order to ensure the firmness of combi-walls, the construction personnel also need to fill and scrape the wall board after correction with polymer mortar. After the combi-walls are shaped, all the joints are pasted tightly with fiberglass cloth.
1.Draw a line in the installation part of combi-walls, so that the line is perpendicular to the beam phase. At the same time, we also need to ensure the material of combi-walls to maintain the smoothness.
2.Next, use the cutting machine to cut combi-walls. As for its specific width and length, we need specific requirements.
3.The next and cement, and at the same time to add some sand, cement and the cement mix in to a paste with stir bar, don't tell the specific shape of cement and sand, then use water in combi-walls first brush on the walls again, make its surface wet, then brush with mortar mixture gently on one floor.
4.The combi-walls are ready to be installed on the position, and then stand up, this time needs to align with the position of the beam line, and then use a spade to composite wall plate, from the bottom to it up, so that the two boards between closely, leaving no gap. At the same time need to use hammer to hit the combi-walls board and wall board between hard close, want to use in front of the mixing of cement, the joint of the two boards not on the cement, at the same time want to ensure that do not leave any gaps, and then with a wooden wedge on the nail to temporarily fix it so that the work is basically completed.
Finally, check whether the combi-walls are installed vertically. After the inspection of the combi-walls, it is necessary to use steel reinforcement to drive into the wall board and its connection parts.The aim is to hold two combi-walls so that they do not shake.
Then a percussion drill is used to make a hole in each of the four corners of the composite wallboard,and then steel is inserted to reinforce combi-walls.Hope this article is helpful for you to understand how to install combi-walls. If you need combi-walls, please contact us.