Tie Rods The tie rods often consist of two rods, each with a nut and tie rod loosening. The length of a single rod up to 20n pad, but also set the tensioner to adjust the length, to avoid the non-
steel sheet piles manufacturers To produce the actual maximum length of the rod is different, if more than two rod, then it should contain two Right turn screw connector.
A tapered plate or special pad can be used when the tie rod axis is not perpendicular to the tie bar base. In some cases, the lever may also pivot the & quot; hinged & quot; anchor about the bearing surface for this effect.
The load acting on the sheet pile is transferred to the tie rod through the plate or bearing plate and then transferred from the rod to the anchor plate. The anchor plate can be a sheet pile, a concrete wall or a single concrete block. When the When the load is transferred to the concrete wall or the concrete block, the anchor plate distributes the load to the concrete. When the load of the concrete block, the anchor plate distributes the load to the concrete. The purlin is transferred to the tie rod through the anchor bolts, a sufficient pressure bearing plate and plate are also required.
steel sheet piles if used in the erosion of the environment, we must consider anti-corrosion, you can use the following methods:
1) bare steel
In this case, consideration should be given to possible corrosion rates and consequent loss of rod diameters in a particular environment.
2) anti-corrosion coating
There are several options, such as painting, plating or parcels. The most common method is to wrap up the rod to achieve corrosion requirements: Anchor head should focus on protection.
